How Do I Get the IP Address of the TF100 TimeClock?
You may need the TF100’s IP Address during set up. This lesson will describe how to set up network access for your TF100 TimeClock, an Internet-enabled biometric time clock.
Step 1: Press the Menu Button.
If there is an Admin fingerprint registered, you might be required to use that to log into the menu screen.
If no admin users have been added, you won’t need to validate an Admin fingerprint.
Step 2: Go To Options
Press the down arrow and highlight “Options”
Step 3: Press OK
After going to the “Options” screen, press the “OK” button.
Step 3: Add an IP Address
Press the down arrow and highlight “IP Addr” and then press OK.
Step 5: Enter the IP address
You should be at the IP Address entry screen.
If there is no IP Address listed, you will need to input one yourself using the number pad. Please enter an IP address that is not currently used on your network.
If there is an IP address already listed, that the device found (for example, using DHCP), write it down for reference.
You will need to remember the IP address for entry into the time clock software.
Step 6: Set the Gateway Option
Next, scroll down to the Gateway option and press OK
This should show you the gateway this device is trying to talk to. Make sure its the same gateway the back office servers are connected to.
When done, press OK. Your TimeClock is completely configured.
What some of our clients have to say ...